What size generator do I need to drive one sump pump of 1/2hp?
- R KLv 710 months ago
look at the sump pump. it will say what watts it's rated at. get a generator with a little
more wattage output than the pump.
- DavidLv 510 months ago
one HP = 745 Watts so you only need half that (373 W) to run steady state. However, starting current draw will be much higher so to get the pump to start reliably you probably need about 1 kW.
- STEVEN FLv 710 months ago
The SMALLEST one available will be far larger than needed.
- GTBLv 710 months ago
At least 1 Kw electrical output
- What do you think of the answers? You can sign in to give your opinion on the answer.
- Anonymous10 months ago
It will require about 600 to 800 watts. A 1.5 kw generator should be good.
- mermelizLv 710 months ago
A Harbor Freight 120 Volt AC, 1/2 HP sump pump draws 6.8 Amps.
So If I were wanting to supply consistent power to only the sump pump, I would connect a minimum 2000 watt generator to it. Providing that the generator is not being used for anything else!Source(s): retired electrician
- TommymcLv 710 months ago
If you don't know the power requirements of your specific pump, there are lots of online charts to help make an estimate. Electric motors need at least double their running current when they start. Here's a chart that suggests a 1/2 hp sump pump would require 1050 running watts, and 3250 starting watts.
That figure of 3250 may be a little on the high side, but it will give you some breathing room.
- Spock (rhp)Lv 710 months ago
look up the startup power draw of the pump's motor, or of a similar pump's motor, add 20 percent for safety and then get a generator bigger than that.